Full Facial Gravel - Front Mudguard Set

Fits in about 3 minutes using 6 zip-ties (supplied), see our fitting instructions.

CombOver (2 zip-ties)

1. Separate the CombOver halves and remove the connecting pieces.
2. Position one half against the frame, reaching the front of where the frame meets the fork crown. The curved part of the spine faces forward, so each side bows upward (like an "n", not a "u") with the slats roughly horizontal.
3. Loop a zip-tie loosely around the CombOver. Avoid trapping any cables.
4. Slide the second half through the zip-tie on the other side. Check both halves sit flush with slats horizontal, then snug it up.
5. Loop the second zip-tie around both halves nearer the front. Tighten both zip-ties and trim the excess.

Toupee Gravel (4 zip-ties):

Choose internal (between the fork legs, under the crown) or external (wraps around outside the legs, above the crown) fit. Most forks have better fit inside (fewer obstacles such as brake hoses), but it will reduce tyre clearance by a couple of mm.

Internal mounting

1. There are 4 pairs of holes on the tongue and 4 outer pairs symmetrically placed that will form a strip to mount inside the fork legs. Lay the Toupee Gravel down with the Fringe pointing forwards and with the tongue attached to the right side.
2. Insert a zip-tie into the forward hole of the pair 2nd from the left, loop through the rightmost tongue pair, and back up through the rear hole of the original pair.
3. Loop 3 more zip-ties through the other pairs from above.
4. Place under the fork crown and between the fork legs, the Fringe in front of the forks above the front wheel. Loop the zip ties around the legs (without trapping any brake hoses) and tighten just enough to hold them in position.
5. Adjust the position so the mounting strip is flush against the inside of the fork legs. For wider forks, another pair of holes in the tongue may fit better.
6. Moving the bottom of each side forwards or backwards against the fork leg will raise or lower the Fringe relative to the tyre.
7. Check the Toupee Gravel is close to, but not rubbing, the tyre and the wheel spins free. Once happy, snug up and trim the excess.

External mounting

1. There are 4 pairs of holes symmetrically placed that form 2 strips to mount flush to the outside of the fork legs. The tongue and its 8 holes are NOT used for this mounting option - ignore them for now, they will be removed at the end.
2. Lay the Toupee Gravel upside down (instructions visible) and loop 4 zip-ties through the hole pairs.
3. Place above and around the fork legs, the Fringe in front of the forks above the front wheel. Loop the zip ties around the legs (without trapping any brake hoses) and tighten just enough to hold them in position.
4. Moving the bottom of each side forwards or backwards against the fork leg will raise or lower the Fringe relative to the tyre.
5. Check the Toupee Gravel is close to, but not rubbing, the tyre and the wheel spins free. Once happy, snug up the zip-ties, trim the excess and trim the tongue to match the other side.